Ski grip tape START Grip Tape (1 pc.)

Universal grip tape - Temperature range +5°...-20°C - Suitable for all types of snow - Easy to use - One application is enough for up to 250 km - Packaging: 5 m, for lubricating 2-3 pairs of skis GRIP TAPE usage video click here Instructions for use (also see diagram on the packaging).

1. Clean the ski grip area (30-50 cm in the middle of the ski) thoroughly with a grease remover (see instructions on the kit). Make sure the area is completely dry after cleaning.
2. Sand the cleaned area with the sandpaper located on the side of the product - side A (see diagram on the packaging). The entire bonding area must be properly sanded, first across and then along.
3. Insert the end of the grip tape into the beginning of the sanded grip area and press down. Apply Grip Tape to the entire grip area of the ski.
4. Cut the Grip Tape as follows: Press with your fingers against the brakes, side C. Lift the box up. Press side D against the grease strip. Twist the cut end into two pieces
5. To prevent air bubbles from forming between the lubricant and the ski surface, firmly smooth the E side over the entire Grip Tape strip.
6. Remove the paper by pulling quickly. If air bubbles remain, replace the paper, smooth the E side again, and remove the paper.
7. Cool the skis outside. Do not touch the lubrication area with your hands and do not press the skis together to prevent the lubrication areas from touching.